Skip to content
Krevo
KREVO Anchor EP
Concrete Repair

KREVO Anchor EP

High-performance pure epoxy anchoring resin · Cartridge-applied · High-load fixings

Type
Anchoring Epoxy
Pack sizes
400 mL cartridge
Shelf life
+5 °C to +30 °C; dry, shaded and frost-free
Technical data sheet

Overview

KREVO Anchor EP is a two-component, pure epoxy resin anchoring grout formulated for fixing starter bars, threaded studs, anchor bolts and sockets in rock, concrete, brick and solid masonry. The cartridge system is suited to horizontal and vertical installations where high bond strength and controlled setting are required.

Advantages

  • High-load anchoring resin with good dimensional stability and resistance to vibration.
  • Styrene-free formulation and low-VOC performance specification.
  • Suitable for horizontal and vertical fixing, including locations near free edges subject to design.
  • Designed for use with anchor bolts, starter bars, threaded rods and anchor sockets.
  • Can be considered for potable-water contact subject to relevant product approval.

Typical uses

  • Starter bars and structural rebar dowels
  • Threaded rod and anchor bolt fixings
  • Steel anchor sockets
  • Connections in concrete, masonry, brick or rock
  • Structural rehabilitation and strengthening works

Technical data

Technical properties

Typical values from the technical data sheet. Always confirm with the current data sheet before use.

Full data sheet

Key performance

KREVO Anchor EP

< 50 g/L

VOC specification

65.5 MPa

7-day compressive yield | ASTM D695

1,310 MPa

7-day compressive modulus | ASTM D695

46 MPa

7-day tensile strength | ASTM D638

1.9%

7-day elongation | ASTM D638

57 °C

Heat deflection temperature | ASTM D648

0.40%

24-hour water absorption | ASTM D570

0.003

Linear coefficient of shrinkage | ASTM D2566

Product information

Chemical base
Two-component, pure epoxy cartridge anchoring grout
Application
Horizontal and vertical installation in sound mineral substrates
Typical substrates
Concrete, brick, solid masonry and rock
Typical fixings
Threaded studs, starter bars, anchor bolts and sockets
Storage temperature
+5 °C to +30 °C; dry, shaded and frost-free
Shelf life
24 months under the stated storage conditions
Permanent service temperature
−40 °C to +72 °C
Temporary service temperature
−40 °C to +120 °C

FAQ

KREVO Anchor EP: questions

What is KREVO Anchor EP?

KREVO Anchor EP is a two-component, pure epoxy resin anchoring grout formulated for fixing starter bars, threaded studs, anchor bolts and sockets in rock, concrete, brick and solid masonry. The cartridge system is suited to horizontal and vertical installations where high bond strength and controlled setting are required.

What is KREVO Anchor EP used for?

KREVO Anchor EP is used for: starter bars and structural rebar dowels; threaded rod and anchor bolt fixings; steel anchor sockets; connections in concrete, masonry, brick or rock; structural rehabilitation and strengthening works.

What pack sizes is KREVO Anchor EP available in?

KREVO Anchor EP is supplied in 400 mL cartridge.

What is the shelf life of KREVO Anchor EP?

Shelf life / storage: +5 °C to +30 °C; dry, shaded and frost-free.

Is there a technical data sheet for KREVO Anchor EP?

Yes. The technical data sheet (PDF) can be downloaded from this page. For project-specific advice or a quotation, send an enquiry to the Krevo technical team.

Ask our team

About: KREVO Anchor EP