Skip to content
Krevo
KREVO Carbon Bond EP
CFRP Systems

KREVO Carbon Bond EP

High-strength thixotropic epoxy adhesive · CFRP strip and plate bonding · Standard & Slow grades

Type
Strip Adhesive
Pack sizes
5 Kg complete packs
Coverage
1 L/m² at a 1 mm nominal adhesive thickness
Shelf life
12 months in sealed packs, dry and shaded below +35 °C
Technical data sheet

Overview

KREVO Carbon Bond EP is a high-build, high-strength, thixotropic epoxy bonding system intended for externally bonded carbon-fiber strips, plates and rods and other approved reinforcing materials. Its non-sag consistency supports durable bonding of structural strengthening components on horizontal and vertical substrates.

Advantages

  • High-strength, non-slump epoxy adhesive for structural strengthening work.
  • Suitable for bonding CFRP strips, pultruded plates and compatible rods.
  • Designed for direct application to properly prepared concrete without a separate primer.
  • Formulated for good adhesion and resistance to a broad range of chemicals.
  • Standard and Slow application grades for differing site conditions.

Typical uses

  • Externally bonded CFRP strips and plates
  • Bonding carbon-fiber rods to concrete
  • Bonding external steel-plate reinforcement
  • Structural rehabilitation of beams, slabs and columns

Technical data

Technical properties

Typical values from the technical data sheet. Always confirm with the current data sheet before use.

Full data sheet

Key performance

KREVO Carbon Bond EP

90 MPa

Compressive strength

23 MPa

Tensile strength

50 MPa

Flexural strength

7 GPa

Compressive modulus

10 GPa

Tensile modulus

33 × 10⁻⁶ /°C

Coefficient of thermal expansion

>18 MPa

Single-lap shear strength

0.4% / >65 °C

Water absorption / Tg (DMTA)

Product information

Material type
Two-component, high-build, thixotropic epoxy adhesive
Intended use
Structural bonding of CFRP strips / plates / rods and approved steel plates
Grades
Standard | Slow
Material consistency
Non-sag, high-strength epoxy bonding paste
Application range
Standard: +5 to +30 °C | Slow: +15 to +45 °C*
Theoretical consumption
1 L/m² at a 1 mm nominal adhesive thickness
Shelf life / storage
12 months in sealed packs, dry and shaded below +35 °C

FAQ

KREVO Carbon Bond EP: questions

What is KREVO Carbon Bond EP?

KREVO Carbon Bond EP is a high-build, high-strength, thixotropic epoxy bonding system intended for externally bonded carbon-fiber strips, plates and rods and other approved reinforcing materials. Its non-sag consistency supports durable bonding of structural strengthening components on horizontal and vertical substrates.

What is KREVO Carbon Bond EP used for?

KREVO Carbon Bond EP is used for: externally bonded CFRP strips and plates; bonding carbon-fiber rods to concrete; bonding external steel-plate reinforcement; structural rehabilitation of beams, slabs and columns.

What pack sizes is KREVO Carbon Bond EP available in?

KREVO Carbon Bond EP is supplied in 5 Kg complete packs.

What is the coverage of KREVO Carbon Bond EP?

Coverage / consumption: 1 L/m² at a 1 mm nominal adhesive thickness. Actual consumption depends on the substrate and application; see the technical data sheet.

What is the shelf life of KREVO Carbon Bond EP?

Shelf life / storage: 12 months in sealed packs, dry and shaded below +35 °C.

Is there a technical data sheet for KREVO Carbon Bond EP?

Yes. The technical data sheet (PDF) can be downloaded from this page. For project-specific advice or a quotation, send an enquiry to the Krevo technical team.

Ask our team

About: KREVO Carbon Bond EP